The controller can be used to operate WS2811 and WS2812B programmable LED strips and LED modules without complicated program codes.

- 84 pre-programmed lighting effects
- 12 speeds
- Recommended LED strip feeding: at least every 5 meters
- Recommended maximum number of controlled pixels: 600
- Input: 5.5 / 2.1mm DC connector (center plus)
- Output: 3P JST SM male connector (G: GND; D: data; C: +5...24V DC)


Use:

Pressing the "Speed" button for a long time turns off the controller, then briefly presses it to turn it on.
By pressing the "Speed" and "Mode +" buttons at the same time, the LED strip lights up white, then the number of pixels to be controlled can be set with the "Mode +" and "Mode -" buttons. The setting can be saved by pressing the "Speed" button.
The light effects can be selected with the "Mode +" and "Mode -" buttons.
The speed of the effect can be set using the "Speed" button.

Attention!
The output voltage is the same as the input voltage!