Widely used NPN and PNP transistor, capacitor, resistor, diode, N-channel and P-channel MOSFET, IGBT, JFET, triac and battery, etc. to test.

It can test a zener diode (zener test connector) and has a self-calibrating function (accessory calibration pin).

It can also be used to detect Hitachi-d infrared waveforms. switched on, the tester displays the data code and the infrared waveform by pressing any button on the infrared remote control towards the receiver marked "IR" on the tester.

One-button operation, automatic detection and shutdown.
Press and hold for 10 seconds to switch the language switch to Asian, and press and hold for another 10 seconds to reset to English.

Insert the legs of the part with up to 3 feet into the different numbered connectors, fold down the sm handle, press the button and the sensor will automaticy test, and finy display the results on the 160x128 color TFT screen.
For Zener diode measurements, use the measuring points marked K (cathode) and A (anode).

Calibration: Insert the 3-pin calibration pin into terminals 1, 2, and 3 of the tester, press the “Start” button and follow the on-screen instructions.


Measuring ranges:

- Resistance: 10mΩ ... 50MΩ,
- Capacitance: 25pF ... 100mF (+ ESR),
- Inductance: 10μH ... 20H (+ resistance)
- Diode: 10mV… 4.5V Si / Geode diode, Schottky, LED, varicap (+ Opening voltage / capacity)
- Zener diode: 10mV… 30V (at the zener measuring point)
- PNP / NPN transistor / darlington, (hFE, opening voltage)
- N- / P- MOSFET, (Gate looping, breakdown)
- JFET,
- Thyristor, triac (IGT less than 6mA)
- IR remote control signal sequence,
- Battery voltage max. Up to 4.5V

Features:

- Display: 160x128 color TFT,
- Power supply: LiPo battery (built-in),
- Device size: 91 x 69 x 28mm

Contents of the package:

1 LCR-TC1
3 measuring cables
1 USB charging cable,
1 sample pack (LED, capacitor)
1 calibration pin.

To avoid malfunctions, pls discharge capacitors and other test items before use.